[HBHRacing]

Ever since I installed my Moser 12 bolt, the stock driveshaft has sat uncomfortably close to the tranny tailshaft housing. becuase of this I still have yet to take the car to the track with the moser. The only way to remedy this is with a custom driveshaft.

So. I am now in contact with the folks at http://www.dennysdriveshaft.com So far they have been 100% great for answering my questions. What I have desided on is.. a custom "nitrous ready 3 inch steel driveshaft with 1350 series U joint/yokes. This is there srtongest driveshaft. The warrent is if I ever break the welds or twist the shaft then they will replace it for free. Also I get massive discounts on any work that is done to that shaft in the future. The total with shipping will be just under 400 bucks. for the ultimate strenth I could upgrade to a billet slip yoke but the cost would go up to just over 500 bucks.


This will be an awesome shaft. If anyone needs a driveshaft, or needs repair of any shaft I highly recomend them. It will be nice to hit the track once I get the shaft on

[Sean]

sweet man, congrats.

[BlackScreaminMachine]

Thats exactly what ill be getting Harlan, ill talk to you later about it, i still need to get the rear first!!

[HBHRacing]

blah blah blah. you have been talking about the 12 bolt forever, get it already

but yeah. 370 bucks for teh last driveshaft you will ever buy? hell yeah.